Wavy scarves weave did: - weaving from 120 needles first line: weaving a line (under the needle) line 2 (plus needle line): under the needle, plus 1 stitch, the next needle, plus 1 stitch. That is, doubling the number of stitches (Note: Here K1 refers to the next needle 1 st, the first translation did not pay attention, of course, that is on the needle) 6,7,8 line until the end, if necessary, can increase the number of lines (Note: here do not understand, literally normal weaving, non-woven plus needle line, personally think that if weaving only 8 lines should not need to add needle , If you want to weave a wider, it should be rewinding a few lines after every other line.) As long as the needle to determine the length of your scarf, I refer to the length and number of needles, we can start a needle, and then weaving To run out of line, if that is not wide enough, you can then pick up a group. This sample is 3 "knitted, relatively small, decorative effect is too warm. Crochet method: colorful sweaters + flower scarves to 14 blocks ~ before and after each of seven as an example ~ according to the thickness of the wool ~ each block The line of 216 is 11 stitches ~ The thick line is 8 stitches ~ At the beginning of weaving 14 triangles ~ The number of stitches of the triangle is more than the number of stitches of the block. Pick a knit stitch ~ 2. In turn weave three stitches stitches ~ turn pick a knit two stitches ~ 3. In turn weave four stitches stitches ~ turn pick a knit three stitches ... ... and so on ~ diy nail plate weaving. Step one: first remove the wool reserve about 100cm long, fixed at the a-end of the nail plate (knotted), by a end to the b-side fixed around Step two: take a different color lines, from a to b the entire loop tie knot Step three: the knot of b open, and then along the winding method around the a point fixed Step four: with 0/3 or 0/5 the lower thread , Pick to the previous level, in order to pick each nails. Step five: use 0/3 or 0/5 hook pin another row of nails under the line, pick to the previous level, each A nail all Step Six: the line fixed in the end of a release, the entire line of the pressure down to orderly tidy.Step seven: in order to rewound again, and then the next level of the line to the previous level, both sides are Must pick. Step eight: Repeat the operation Winding → pick the needle → Winding → pick the needle → ........, the length of the required preparation of the next nail plate. This is the easiest way, the most important thing is you Needle plate, crochet, wool. There are many kinds of scarves, there are nail plate, barber, crochet, castle weavers. Weaving of beautiful scarves Needle: 4 needles plus 2 needles I got 26 needles, a little narrow , Suitable for wearing a single coat around the time. Line 1: Repeatedly woven "2-pin on the 2-pin down", the last two needles are woven needle. Line 2: On the last two needles are woven under the needle. Line 3: on the needle (down from above the line poke) down 2-pin and 1 needle, wire wound up (as 2 needle 2 needle under the next, Up and down the same, the thread around the next needle and when the needle is around the right hand needle, that is, plus a needle), and then down the needle (down from the line down) 2-pin and 1 Needle. Then wire wound Be repeated, and finally wound up two needles front, about a pin, are the last two knitting needles on the needle line 4: the same weave repeat with the upper four rows of the second rows of knitting.
Award Medals
Award Medals is one of our Metal Medals, it`s used for any
activities/games/agent/, and no limited for sex and age. Sometimes we make them
based on Zinc alloy/iron/brass/aluminum, but zinc alloy is the most popular
material, because it`s allowed big size and difficulty designs. For aluminum,
could allow a lot of metal base color if you want.
Description of Award Medals:
Item: Award Medal
Process: Die casting/Stamping/Printing
Design: Customized (2D/3D)
Material: Zinc
alloy/iron/copper/brass/aluminum
Size: Standard size or custom size
Thickness: Standard size or customized
Plating: Imitation gold/real
gold/antique gold/misty gold/silver/misty silver/antique silver/brass/misty
brass/antique brass/copper/misty copper/antique copper/nickel/misty
nickel/antique nickel/chrome
Color: Custom (soft enamel/hard
enamel/synthetic enamel/printing)
Attachment: Ribbon (existing
ribbon/logo design by customer)
MOQ: 50pcs
Usage: Games
Packing: 1pc/ribbon/polybag
QC Control: 100% inspection before
packing, spot inspection before shipment
After-sale service: Free replacement if
find out any short or defective goods within 90 days after shipment
Sample time: 7-12 days
Production time: 18-20 days
Shipment: TNT/UPS/DHL/FEDEX/BOAT
Payment: 100% in advance for small
orders; 30% deposit, 70% before shipment for big orders.
Award Medals
Award Medals,Kids Soccer Medals,Running Medals,Custom Award Medals
Artilanyard Co., Ltd. , http://www.grmgifts.com